Do I have to take the New Mexico journeyman electrician exam if I'm licensed in New York?

Yes. New Mexico requires the trade exam on this path.

What does it cost to get a New Mexico journeyman electrician license from New York?

Published fees on this path total $281.64, not counting exam vendor fees or bonds.

Do my New York work hours count in New Mexico?

Yes. Documented out-of-state experience counts toward New Mexico's eligibility requirements.

Does it work the other way, from New Mexico to New York?

Not necessarily. Reciprocity is directed. Going from New Mexico to New York, the mechanism is not applicable.

New York to New Mexico: journeyman electrician license reciprocity

No credit· Start overVerified September 15, 2026· 6 sources

New York does not issue a statewide journeyman electrician license, so there is nothing to transfer. Here is New Mexico's standard path for out-of-state applicants.

Your origin state does not issue a statewide license at this level, so there is no license to transfer. The destination's standard out-of-state path is shown; expect to meet it in full.

Reference only, not legal advice. Rules change; confirm with the licensing board before you apply. Full disclaimer.

Out-of-state journeyman without a reciprocity agreement

Your out-of-state credentials give no advantage. You meet the destination's requirements from scratch.

CID publishes no endorsement process for journeymen from states outside its EE-98J reciprocity list, and 14.6.4 NMAC contains no general reciprocity provision (only an expedited path for military service members, spouses and veterans). An applicant from a non-reciprocal state files the standard notarized Journeyman Certificate Application with PSI, documents 8,000 hours of experience within the past ten years on notarized work-experience forms, and must pass all three parts of the EE-98J exam. Out-of-state experience counts if it was gained while employed by a contractor licensed in the trade or was legal work in the state where it was performed. New Mexico has no separate law exam for journeymen; state code questions are part of the Part 1 Code exam.

All certification requirements must be met within six months of CID receiving the application, and passing scores are valid for one year. Whether CID would waive the exam for a non-listed state under NMSA 60-13-14(C) is not addressed on any official page.

At a glance

Trade exam: Required
Law / code exam: Not required
Out-of-state hours: Count toward eligibility

What you must already have

You must document at least 8,000 hours of qualifying work experience.Four years of accredited training, apprenticeship or practical experience in the electrical trade (two years commercial/industrial), gained within the ten years before application (NMSA 60-13-38(I); 14.6.4.8(C) NMAC).

What you'll do to get licensed in New Mexico

1Application fee. Pay the application fee ($75). Journeyman Certificate Application fee paid to PSI (per classification).
2Trade exam. Pass the destination's trade exam. EE-98J exam: Part 1 Code (50 questions, open book, 2020 NEC), Part 2 Theory (closed book) and a practical exam; 75% required on each.
3Exam fee. Pay the exam fee ($206.64). PSI exam combination fee for the three EE-98J parts ($68.88 per part, charged per attempt).

Published fees on this path total $281.64, excluding exam-vendor fees, bonds, and insurance.

What you'll need to buy or arrange

Exam preparation

Most boards contract PSI, Prov, or ICC for exams. Check which code edition the exam is written to before buying a prep course.

Trade exam
Exam fee · $206.64

How New Mexico licenses journeyman electricians

New Mexico journeyman electrician · “EE-98J Journeyman Electrician (certificate of competence)”

Statewide license

Verified September 15, 2026· 5 sources

Issued by New Mexico Regulation and Licensing Department, Construction Industries Division (CID)

New Mexico issues statewide journeyman certificates of competence through the Construction Industries Division (CID) of the Regulation and Licensing Department; PSI processes applications and administers the exams under contract. The residential and commercial journeyman electrician classification is EE-98J, which requires four years (8,000 hours) of experience gained within the ten years before application; a residential-only ER-1J and several two-year specialty journeyman classifications also exist. A new EE-98J applicant passes a two-part written exam (Part 1 Code, open book on the 2020 NEC; Part 2 Theory, closed book) and a practical exam, each with a 75% passing score. CID reciprocates only the EE-98J classification, with ten states. Certificates are active for three years, and EE-98J holders complete 16 hours of continuing education per three-year code cycle.

Moving to New Mexico Leaving New Mexico

Why New York has nothing to transfer

New York journeyman electrician

Licensed by cities and counties

Verified September 15, 2026· 15 sources

New York has no statewide electrician license at any level: the Department of State's Division of Licensing Services issues no electrician license, and its only page on the subject treats master electrician licenses as credentials issued by local governments. Journeyman-level licensing therefore exists only where a city or county ordinance creates it, and most jurisdictions do not. New York City licenses only Master and Special Electricians; journeymen and helpers work as employees under a licensed master or special electrician without any personal license, and their supervised hours (at least two years in the city) are what later qualify them for the master exam. Buffalo is the main city with a true Journeyman Electrician license (five years under a licensed master plus a New York State journeyman card, an ICC exam or a city exam), and Suffolk County carries a journeyman category in its Consumer Affairs licensing codes. Rochester's lower tier is a Single-Phase (residential) license rather than a journeyman card. An out-of-state journeyman license has no state-level recognition in New York; a journeyman should confirm the rules of the specific city or county where they will work and, in most places, simply work for a licensed master while accumulating local hours.

How local licensing works in New York

How local licensing works. No state agency licenses electricians in New York. Each city or county that requires a license runs its own examining board under its own ordinance, so requirements, exams and fees differ from one jurisdiction to the next, and a license from one jurisdiction is not automatically valid in another.

New York City. The Department of Buildings issues Master Electrician and Special Electrician licenses only; there is no journeyman license or registration. Electricians work as employees under a licensed master or special electrician. Experience toward the master license must be gained 'under the direct and continuing supervision of a licensed master or special electrician in the United States', with at least two of the required years in New York City, so out-of-state supervised hours count toward the master exam but do not create any journeyman credential.

Buffalo. The Electrical Examining Board issues a Journeyman Electrician License. Minimum qualification is five years working as an employee of a licensed master electrician (not self-employed), plus one of: a New York State journeyman electrician license/card, a passing ICC exam score together with the five years of experience, or at the board's discretion other proof such as a passing score on a City of Buffalo-administered exam. The notarized application lists every master electrician worked for with dates and hours, supported by master electrician affidavits.

Rochester. No journeyman license. The Electrical Examining Board issues a Single-Phase (residential) license requiring two years of applicable experience, interpreted as at least 3,000 hours within the past five years (at least half in the field with tools, up to 1,500 hours from course work or estimating/design/supervision), and an ICC-based exam with a 70 percent passing grade.

Syracuse and Albany. Both cities license electricians through their own examining boards (Syracuse Division of Code Enforcement; Albany Electrical Examining Board under General Code Chapter 171, Article III). The pages that could be opened describe master-level licensing and application deadlines but publish no journeyman card requirements.

Suffolk County. The Department of Consumer Affairs licenses Master Electricians and Restricted Electrical licensees and its licensing code list includes an 'AJ - Journeyman' category; the journeyman requirements themselves are not on the pages that could be opened.

Westchester County and Yonkers. Westchester County issues master and special electrician licenses by examination; it has no journeyman license. Yonkers does not license electricians itself and its electrical permits are issued to master electricians licensed by Westchester County.

Nassau County. The county's FAQ recognizes electricians as a trade held to a 'standard of competency' by state or local law, but no page describing a Nassau electrician license could be opened; treat Nassau's requirements as unverified.

Out-of-state holders. No jurisdiction above publishes a reciprocity or endorsement path for a journeyman license from another state. Buffalo will accept an ICC exam score with five years of experience under any licensed master; elsewhere an arriving journeyman works under a locally licensed master electrician until eligible for that jurisdiction's master exam.

Moving to New York Leaving New York

Common questions

Do I have to take the New Mexico journeyman electrician exam if I'm licensed in New York?: Yes. New Mexico requires the trade exam on this path.
What does it cost to get a New Mexico journeyman electrician license from New York?: Published fees on this path total $281.64, not counting exam vendor fees or bonds.
Do my New York work hours count in New Mexico?: Yes. Documented out-of-state experience counts toward New Mexico's eligibility requirements.
Does it work the other way, from New Mexico to New York?: Not necessarily. Reciprocity is directed. Going from New Mexico to New York, the mechanism is not applicable.

Sources

Construction Industries Licensing Act, NMSA 1978 Chapter 60, Article 13 · NMSA 1978 §§ 60-13-2(E), 60-13-14, 60-13-16, 60-13-38 · New Mexico Regulation and Licensing Department · Statute · verified September 15, 2026§60-13-2(E): a 'qualifying party' is an individual who submits to the examination for a license and is responsible for the licensee's compliance. §60-13-14(A)(8): a contractor license applicant needs four years of trade experience within the ten years before application. §60-13-14(C): the division, with the commission's consent, may enter into a reciprocal licensing agreement with any state having equivalent licensing requirements. §60-13-16: no certificate of qualification is issued until the individual passes the division's exam, which includes business/law and, for EE classifications, a technical exam; the certificate is not transferable. §60-13-38: journeymen must hold a certificate of competence obtained by examination; eligibility for the journeyman electrician exam requires four years of accredited training, apprenticeship or practical experience (two years commercial/industrial); 16 hours of continuing education per three-year code cycle for EE-98J.
14.6.4 NMAC - Certification of Journeymen (Construction Industries Division) · 14.6.4.8 NMAC · New Mexico Commission of Public Records, State Records Center and Archives · Admin Rule · verified September 15, 2026Passing score is 75% or higher; retakes allowed but not more than twice in any 30-day period; all certification requirements must be met within six months of the application or fees are forfeited. The only reciprocity/expedited provision is 14.6.4.8(D) for military service members, spouses, dependents and veterans certified in another jurisdiction with substantially equivalent requirements. Continuing education: 16 hours per renewal (8 on the enforced code) applies to mechanical journeymen JSM, JS and JR among others.
14.6.6 NMAC - Classification and Scope of Licenses and Certificates (mechanical and plumbing) · 14.6.6.10 and 14.6.6.11 NMAC · New Mexico Commission of Public Records, State Records Center and Archives · Admin Rule · verified September 15, 2026MM-3 Heating, Ventilation and Air Conditioning: four years of experience; scope is to 'install, alter, repair, service and maintain HVAC air handling and refrigeration equipment and piping, including fans, coils, condensing units, self-contained packaged air conditioning or heating units, evaporative cooling units, and ductwork' plus controls at 24 volts or less. MM-98 Mechanical (four years) covers MM-1 through MM-4 and the MS-3, MS-6, MS-12 and MS-14 specialties. Journeyman classifications: JR Journeyman Refrigeration (two years; 'must demonstrate compliance with environmental protection agency (EPA) recovery requirements before certificate may be issued'; works under MM-3, MM-4, MM-98 or JSM) and JSM Journeyman Sheet Metal (two years; works under MM-3 or MM-98).
PSI - How to Obtain a New Mexico Journeyman Certificate · PSI Services for the NM Construction Industries Division · Form · verified September 15, 2026Application packet: notarized Journeyman Certificate Application, notarized work experience verification forms, $75 application fee per classification. Experience table: EE-98J and EL-1J four years (8,000 hours); ER-1J and ES specialty classifications two years (4,000 hours). All experience must have been gained while employed by a contractor licensed in the trade, or be considered legal work in the state where performed. 'Reciprocity applicants do not need to submit work experience forms; however must be currently active for at least one year in the state in which they tested.' Certificates are active for three years. Document last revised 4/19/2011 but still published by PSI.
State of New Mexico Journeyman Examinations Candidate Information Bulletin (PSI) · PSI Services for the NM Construction Industries Division · Other · verified September 15, 2026Text extracted from the PDF locally. Fee table: JR Journeyman Refrigeration $68.88 (single exam); JSM Journeyman Sheet Metal Written $68.88 and Practical $68.88, combination $137.76; fees are charged per attempt and are not refundable. JR exam: 50 questions, 120 minutes, 75% (38 points) to pass, open book on the 2015 New Mexico Mechanical Code (14.9.2 NMAC), 2021 Uniform Mechanical Code and Modern Refrigeration and Air Conditioning. JSM written: 70 questions, 185 minutes, 75%; JSM practical: 100 points, 120 minutes, 75%. Candidates must be pre-approved by PSI before testing.
NM Regulation and Licensing Department - Apply for a Construction Industries License · New Mexico Regulation and Licensing Department, Construction Industries Division · Agency Page · verified September 15, 2026Section 'Reciprocal Journeyman in New Mexico': 'The only journeyman classification reciprocated in New Mexico is EE-98J, residential and commercial electrical'; no mechanical or refrigeration journeyman classification is reciprocated. Section 'Becoming a Qualifying Party': QP applicants need the required years of experience within the 10 years before application, must pass the classification exam(s) and a Contractor's Business and Law exam, must be pre-approved to schedule exams, and pay a $36 QP application and work-experience affidavit fee; the company license application fee is $36 plus license fees. No reciprocity is mentioned for qualifying parties or contractors.

Verified dates are when a person last opened each source and confirmed the facts above. Cite the board, not us.

Report an error on this page