LicensebyState

New York to Connecticut: master electrician license reciprocity

No credit· Start overVerified September 15, 2026· 6 sources

New York does not issue a statewide master electrician license, so there is nothing to transfer. Here is Connecticut's standard path for out-of-state applicants.

Your origin state does not issue a statewide license at this level, so there is no license to transfer. The destination's standard out-of-state path is shown; expect to meet it in full.

Reference only, not legal advice. Rules change; confirm with the licensing board before you apply. Full disclaimer.

Contractor (E-1) by equivalent out-of-state license (all states)

Your out-of-state credentials give no advantage. You meet the destination's requirements from scratch.

A master electrician or electrical contractor licensed in any other state applies under DCP's 'Electrical Contractor - Equivalent Out of State License' path. DCP reviews a single out-of-state license for equivalency to the E-1: it must have required 720 classroom hours with a curriculum matching Exhibit A, 8,000 apprentice OJT hours and two years (4,000 hours) of licensed OJT, 12,000 hours in total. The applicant submits a copy of the license, an official license verification, the laws and regulations that set the requirements met to obtain it, and the scope of work for that license, with the non-refundable $150 application fee. If approved, the applicant must pass both the E-1 trade exam and the Business and Law exam through PSI ($59 per portion) and then pay the $150 initial license fee; the out-of-state license does not waive either exam because Connecticut has no reciprocal agreements. An applicant whose license is not found equivalent must document the classroom and OJT hours directly under the equivalent experience and training path.

The out-of-state license page does not restate the exam requirement; it follows from the Electrical License page, CGS 20-333 and the PSI bulletin, which states that all contractors must pass a Business and Law examination and a trade examination. CGS 20-333a allows licensure without examination only where the other state reciprocates for Connecticut licensees, and DCP states no such agreements exist. Whether DCP treats an out-of-state 'master' license (rather than a contractor license) as the E-1 equivalent depends on the hour and curriculum comparison; DCP publishes no list of accepted titles.

At a glance

Trade exam
Required
Law / code exam
Required
Out-of-state hours
Count toward eligibility

What you must already have

  • Your New York license must be active and in good standing.
  • The out-of-state license must be equivalent: it required 720 classroom hours matching Exhibit A, 8,000 apprentice OJT hours and 4,000 licensed OJT hours (12,000 total)Only one out-of-state license is reviewed for equivalency.
  • You must document at least 12,000 hours of qualifying work experience.8,000 hours as an apprentice plus 2 years (4,000 hours) working as a licensed journeyperson.

What you'll do to get licensed in Connecticut

  1. 1Application fee. Pay the application fee ($150). Contractor application fee, non-refundable (CGS 20-333).
  2. 2Other. Copy of the out-of-state license, official license verification, the laws/regulations listing the requirements met to obtain it, and the scope of work for that license.
  3. 3Trade exam. Pass the destination's trade exam. E-1 Unlimited Electrical Contractor trade exam administered by PSI: 100 questions, 4 hours, 70% to pass, open book (2020 or 2023 NEC).
  4. 4Law / code exam. Pass a law, rules, or code exam. Connecticut Business and Law exam (PSI): 50 questions, 2 hours, 70% to pass, based on the NASCLA Contractors Guide to Business, Law and Project Management, Connecticut 6th edition.
  5. 5Exam fee. Pay the exam fee ($59). PSI fee for the trade portion (same fee for retakes).
  6. 6Exam fee. Pay the exam fee ($59). PSI fee for the Business and Law portion (same fee for retakes).
  7. 7License fee. Pay the license or certificate fee ($150). Initial license fee for a contractor's license after passing both exams (CGS 20-335); renews annually for $150.

Published fees on this path total $418, excluding exam-vendor fees, bonds, and insurance.

What you'll need to buy or arrange

Exam preparation

Most boards contract PSI, Prov, or ICC for exams. Check which code edition the exam is written to before buying a prep course.

  • Trade exam
  • Law / code exam
  • Exam fee · $59
  • Exam fee · $59

How Connecticut licenses master electricians

Connecticut master electrician · “E-1 Unlimited Electrical Contractor”

Statewide license

Verified September 15, 2026· 5 sources

Issued by Connecticut Department of Consumer Protection, Occupational and Professional Licensing (Electrical Work Examining Board)

Connecticut has no license titled 'master electrician'; the top-tier personal license is the E-1 Unlimited Electrical Contractor, issued by DCP to an individual (DCP licenses individuals, not companies) and permitting all electrical work under CGS 20-330, pulling permits and contracting with the public. A new E-1 applicant needs 720 classroom hours matching DCP's Exhibit A curriculum and 12,000 OJT hours (8,000 as an apprentice plus 4,000 hours, two years, working as a licensed journeyperson), reachable through two years as a Connecticut journeyperson, equivalent experience and training, or an equivalent out-of-state license, and must pass both the PSI E-1 trade exam (100 questions, 4 hours, 70%) and the Business and Law exam (50 questions, 2 hours, 70%). DCP states that Connecticut does not have reciprocal agreements with any other jurisdiction. Fees are a $150 application fee, $59 per exam portion and a $150 initial license fee; licenses expire every September 30 and renew for $150.

Moving to ConnecticutLeaving Connecticut

Compare: getting a Connecticut license from scratch

Why New York has nothing to transfer

New York master electrician

Licensed by cities and counties

Verified September 15, 2026· 18 sources

New York issues no statewide master electrician license; the Department of State's Division of Licensing Services licenses no electricians, and master electrician licenses are issued by city and county examining boards under local ordinances. The largest is New York City's Department of Buildings Master Electrician license (with a companion Special Electrician license for in-house work), which requires seven years of experience within the last ten working with tools under a licensed master or special electrician in the United States, at least two of them in New York City, a $585 written and $530 practical exam, a background investigation, and a New York City business with general liability, workers' compensation and disability insurance; the license costs $310 and is renewed yearly for $60. Buffalo requires 11 years (22,000 hours) of experience and a 75 percent ICC G-16 score; Rochester requires four years (6,000 hours of three-phase work) and an ICC-based exam; Westchester County licenses master and special electricians by examination ($500 license) and its license is what Yonkers permits require; Suffolk County licenses master and restricted electricians; Syracuse and Albany run their own boards. None of these jurisdictions publishes a reciprocity or endorsement path for a master license from another state, although Westchester's fee schedule lists a 'Reciprocal Electrician' license category. A master electrician arriving from another state must qualify with each local board where they intend to work, and in New York City must first accumulate two years of supervised experience inside the city.

How local licensing works in New York

How local licensing works. New York has no state electrical board. Licensing authority rests with individual cities and counties, each with its own examining board, ordinance, exam and fee schedule; a license is valid only in the issuing jurisdiction.

New York City. The Department of Buildings issues the Master Electrician license (independent contracting anywhere in the city) and the Special Electrician license (work as an employee in or on specific buildings). Qualifications (NYC Admin. Code 28-430.3; 1 RCNY 104-01): age 18, read and write English, fitness and good moral character, and one of: seven years within the last ten working with tools on wiring and appliances for light, heat and power under the direct and continuing supervision of a licensed master or special electrician in the United States, at least two years of it in NYC; a bachelor's degree in electrical engineering or engineering technology plus three years within five (two in NYC); a New York State DOL-registered apprenticeship plus five years within ten (two in NYC); or electrical-inspection employment credited at 50 percent up to 2.5 years. Candidates pay $585 for the closed-book written exam on the 2025 NYC Electrical Code (70 percent to pass) and $530 for the practical, which must be passed within 24 months of the written result; the background application (experience verification signed by supervisors, Social Security earnings history, physical exam) is filed through DOB NOW within one year. License fee $310, seal $50, annual renewal $60 with continuing education, late renewal $310. The licensee must be an officer, partner or sole proprietor of a business with a NYC location carrying general liability, workers' compensation and disability insurance. The exam can be waived only for city-agency applicants (28-430.6); no out-of-state waiver exists, and the two-years-in-NYC rule means an out-of-state master cannot qualify immediately.

Buffalo. The Electrical Examining Board's Master Electrician License requires 11 years (22,000 hours) of experience in electrical construction within the last 11 years, structured as four years (8,000 hours) as an apprentice plus seven years (14,000 hours) as a journeyman working for a licensed master, documented by notarized employer and master electrician affidavits; a passing (75 percent or higher) ICC G-16 Master Electrician exam taken within one year; a $100 application fee; and general liability and workers' compensation certificates before issuance. The master electrician affidavit asks in which city the supervising master is licensed, so experience under masters licensed elsewhere is accepted as documentation.

Rochester. The Electrical Examining Board issues a Master (three-phase) license requiring four years of applicable experience, interpreted as at least 6,000 hours of three-phase experience within the past ten years (at least half in the field with tools; up to 3,000 hours may be course work, estimating, design, supervision or single-phase work), and an ICC-based exam with a 70 percent passing grade. Applications are filed online; the Board's rules contain no reciprocity clause.

Westchester County and Yonkers. The Department of Consumer Protection's Electrical Board licenses Master and Special Electricians by examination: exam application $50, master license $500 with $500 annual renewal, special electrician $350. The fee schedule also lists a 'Master and Reciprocal Electrician' license at the same $500, but the conditions for a reciprocal license are not published on the pages that could be opened. Yonkers does not license electricians; its electrical permits are issued to master electricians licensed by Westchester County.

Suffolk County. The Department of Consumer Affairs issues Master Electrician and Restricted Electrical licenses (codes ME and RE). Experience, exam and fee details are in the county code and were not available on the pages that could be opened.

Syracuse and Albany. Syracuse licenses electricians through its Division of Code Enforcement (2026 applications were due June 26 with in-person consideration July 28). Albany's Electrical Examining Board, under General Code Chapter 171, Article III, examines every applicant and includes master electricians licensed by the city for at least five years. Neither city publishes reciprocity rules on the pages reviewed.

Nassau County. The county FAQ treats electricians as a trade licensed under a 'standard of competency', but no Nassau page describing the master electrician license, its requirements or fees could be opened, so Nassau's rules are unverified here.

Out-of-state holders. No New York jurisdiction reviewed publishes an agreement with another state. The practical route is to meet each local board's experience threshold (documented under licensed masters, wherever they were licensed, where the board allows), pass that board's exam, which in Buffalo, Rochester and several other boards is an ICC exam that may already have been taken elsewhere, and pay the local fees; in New York City the two years of supervised experience inside the city must be earned first.

Moving to New YorkLeaving New York

Common questions

Do I have to take the Connecticut master electrician exam if I'm licensed in New York?
Yes. Connecticut requires the trade exam on this path, plus a law or code exam.
What does it cost to get a Connecticut master electrician license from New York?
Published fees on this path total $418, not counting exam vendor fees or bonds.
Do my New York work hours count in Connecticut?
Yes. Documented out-of-state experience counts toward Connecticut's eligibility requirements.
Does it work the other way, from Connecticut to New York?
Not necessarily. Reciprocity is directed. Going from Connecticut to New York, the mechanism is not applicable.

Sources

  1. Connecticut General Statutes Chapter 393 - Occupational Licensing (Electrical, Plumbing and Piping, Heating, Cooling...) · CGS §§ 20-330, 20-333, 20-333a, 20-334a, 20-335 · Connecticut General Assembly · Statute · verified September 23, 2026
  2. Connecticut DCP - Electrical Contractor: Equivalent Experience and Training · Connecticut Department of Consumer Protection · Agency Page · verified September 23, 2026
  3. Connecticut DCP - Electrical Contractor: Equivalent Out of State License · Connecticut Department of Consumer Protection · Agency Page · verified September 15, 2026
  4. Connecticut DCP - Electrical License (application paths, fees, renewal) · Connecticut Department of Consumer Protection · Agency Page · verified September 23, 2026
  5. Connecticut DCP - Electrical License Types and Scope of Work · Connecticut Department of Consumer Protection · Agency Page · verified September 15, 2026
  6. Connecticut DCP Occupational Licensing - Electrical Trades Candidate Information Bulletin (PSI, updated 2/4/2026) · Connecticut Department of Consumer Protection / PSI Services LLC · Form · verified September 23, 2026

Verified dates are when a person last opened each source and confirmed the facts above. Cite the board, not us.

Report an error on this page

Related