South Carolina to Connecticut: journeyman HVAC technician license reciprocity
South Carolina does not issue a statewide journeyman HVAC technician license, so there is nothing to transfer. Here is Connecticut's standard path for out-of-state applicants.
Your origin state does not issue a statewide license at this level, so there is no license to transfer. The destination's standard out-of-state path is shown; expect to meet it in full.
Reference only, not legal advice. Rules change; confirm with the licensing board before you apply. Full disclaimer.
Journeyperson by equivalent out-of-state license (all states)
Your out-of-state credentials give no advantage. You meet the destination's requirements from scratch.
An HVAC technician licensed in any other state applies under DCP's 'Heating Journeyperson - Equivalent Out of State License' path. DCP reviews one out-of-state license for equivalency: it must have required the same number of classroom hours (576 for the S-2), an equivalent classroom curriculum matching DCP's Exhibit A courses, and the same on-the-job training hours (8,000 for the S-2) as the Connecticut license applied for; the limited D-2 class needs 4,000 OJT and 432 classroom hours and the B-2 needs 2,000 and 288. The applicant submits a copy of the license, an official license verification, the laws and regulations that set the requirements met to obtain it, and the scope of work for that license; only one license will be reviewed and the $90 application fee is non-refundable. If the license is found equivalent, DCP approves the applicant to sit the S-2 exam with PSI ($59 per portion, eligibility valid one year), and the license is issued after passing on payment of the $120 initial license fee. The out-of-state license does not waive the Connecticut exam because Connecticut has no reciprocal agreements. If the license cannot be shown equivalent, the applicant must instead document 576 classroom hours and 8,000 OJT hours with transcripts and notarized employer letters under the equivalent experience and training path.
DCP's out-of-state license page does not itself restate that the exam is required; the exam requirement follows from the Heating, Cooling and Sheet Metal Work Licenses page (every individual applicant must take an exam), CGS 20-334a(a)(2) (competency shown by the state licensure examination) and the PSI bulletin (the State determines eligibility, then the candidate tests). CGS 20-333a permits licensure without examination only where the other state reciprocates for Connecticut licensees, and DCP states no such agreements exist. Many states issue a single HVAC or refrigeration license rather than a heating-piping-cooling license with a 576-hour curriculum, so an applicant may be found equivalent only to a limited class such as the D-2. Neither DCP page mentions EPA Section 608; it is a federal requirement that applies regardless. Typical processing time is not published.
At a glance
- Trade exam
- Required
- Law / code exam
- Not required
- Out-of-state hours
- Count toward eligibility
What you must already have
- Your South Carolina license must be active and in good standing.
- The out-of-state license must be equivalent: it required the same classroom hours (576 for the S-2; 432 for the D-2; 288 for the B-2), an equivalent curriculum matching Exhibit A, and the same OJT hours (8,000 S-2; 4,000 D-2; 2,000 B-2) as the Connecticut class applied forOnly one out-of-state license is reviewed for equivalency.
- You must document at least 8,000 hours of qualifying work experience.On-the-job training hours required for the S-2; demonstrated through the equivalent out-of-state license or, failing that, through notarized employer letters under the experience and training path.
What you'll do to get licensed in Connecticut
- 1Application fee. Pay the application fee ($90). Journeyperson application fee, non-refundable (CGS 20-333).
- 2Other. Copy of the out-of-state license, official license verification, the laws/regulations listing the requirements met to obtain it, and the scope of work for that license.
- 3Trade exam. Pass the destination's trade exam. S-2 Unlimited Heating, Piping and Cooling Journeyperson exam administered by PSI: 70 questions, 3 hours, 70% to pass, open book (D-2: 60 questions, 2 hours; B-2: 40 questions, 1.5 hours).
- 4Exam fee. Pay the exam fee ($59). PSI examination fee per portion, not refundable or transferable (same fee for retakes).
- 5License fee. Pay the license or certificate fee ($120). Initial license fee for a journeyperson license after passing the exam (CGS 20-335); renews annually for $120, expiring August 31.
- 6Other. Hold EPA Section 608 technician certification to handle refrigerant; federal law requires it, but it is not a condition of this state license (if applicable).
Published fees on this path total $269, excluding exam-vendor fees, bonds, and insurance.
What you'll need to buy or arrange
Exam preparation
Most boards contract PSI, Prov, or ICC for exams. Check which code edition the exam is written to before buying a prep course.
- Trade exam
- Exam fee · $59
- Other · if applicable
How Connecticut licenses journeyman HVAC technicians
Connecticut journeyman HVAC technician · “S-2 Unlimited Heating, Piping and Cooling Journeyperson”
Statewide license
Connecticut licenses HVAC work statewide through the Department of Consumer Protection (DCP) as 'heating, piping and cooling' work; the journeyman-level credential is the S-2 Unlimited Heating, Piping and Cooling Journeyperson, which covers all heating, piping and cooling work defined in CGS 20-330 while employed by a licensed contractor. Narrower journeyperson classes exist for technicians whose experience is limited to part of the trade, chiefly the D-2 Limited Warm Air, Air Conditioning and Refrigeration Journeyperson (no oil burner servicing) and the B-2 Limited Gas and Oil Burner Journeyperson, plus D-4 cooling-only, G-2 gas piping and S-10 light heating-cooling classes. A new S-2 applicant qualifies through a Connecticut apprenticeship, through equivalent experience and training (8,000 on-the-job hours and 576 classroom hours), or by holding an equivalent out-of-state license, and in every path must pass the PSI-administered S-2 exam (70 questions, 3 hours, 70%, open book). DCP states that Connecticut does not have reciprocal agreements with any other jurisdiction, even though CGS 20-333a would allow the Commissioner to waive the exam for licensees of states that reciprocate. The application fee is $90, the exam is $59 per portion and the initial license fee is $120; licenses expire every August 31 and renew for $120. EPA Section 608 refrigerant certification is a separate federal requirement for anyone handling refrigerants.
Why South Carolina has nothing to transfer
South Carolina journeyman HVAC technician · “Journeyman HVAC trade certification card (CAGC SC Trades Certification, formerly MASC) - not a state license”
Licensed by cities and counties
Issued by Local building departments, using the CAGC SC Trades Certification (formerly MASC) journeyman card
South Carolina has no state journeyman HVAC license. The LLR Contractor's Licensing Board licenses mechanical contractors (entities qualified by an individual qualifying party) for air-conditioning, heating and refrigeration work over $10,000, and the Residential Builders Commission licenses Residential HVAC Installers and Repairers for residential work over $500; neither chapter of the contractor law creates a journeyman or technician credential, so an HVAC technician who is not a contractor works under one of those licensees with no state license. The journeyman-level credential that does exist is the trade certification card of the SC Mechanical Trades Certification Program, run since 1965 by the Municipal Association of South Carolina (the association of the state's cities) and, since January 1, 2026, by the Carolinas AGC Foundation; the program's own page says the card is not a license and must not be represented as one. No reciprocity or out-of-state acceptance is published for the journeyman card, so an arriving technician should expect to apply to CAGC ($35 application, PROV exam) if a local jurisdiction or employer requires a card. EPA Section 608 certification is federal and required of everyone handling refrigerants regardless of any South Carolina card.
How local licensing works in South Carolina
How local licensing works. State law licenses contractors, not technicians: S.C. Code § 40-11-30 requires a Contractor's Licensing Board license (Mechanical Contractor with the Air Conditioning, Heating, Refrigeration or Packaged Equipment classification) for mechanical contracting work whose total cost exceeds $10,000, and Chapter 59 requires a Residential Builders Commission license for residential heating and air-conditioning work over $500. Employees of those licensees need no state credential. The Contractor's Licensing Board home page lists no journeyman license, and the Residential Builders Commission licenses the Residential HVAC Installer and Repairer, not a journeyman.
The trades certification card. The SC Mechanical Trades Certification Program was created in 1965 by the Municipal Association of South Carolina to give municipalities a common examination and certification for the mechanical trades. MASC handed the program to the Carolinas AGC Foundation on January 1, 2026; cards issued by MASC remain valid until the expiration printed on them, and CAGC now issues verification letters. CAGC charges a $35 application fee ($35 to re-test), uses PROV as its exam provider, and states that the card 'should not be confused with' the LLR mechanical contractor or residential specialty licenses and that a holder will not represent the card as evidence of a license. The master-level HVAC card, the HARV (Master Mechanical) certification issued by exam by MASC between September 7, 2013 and December 2025 or by CAGC after January 1, 2026, is accepted by LLR as a technical-exam waiver for the Mechanical Contractor Air Conditioning and Heating classifications and for the Residential HVAC Installer and Repairer license, which is the card's main statewide use. Technicians should ask the local building department where they will work.
Out-of-state holders. Neither CAGC nor MASC publishes reciprocity for journeyman licenses from other states, and LLR's waiver agreements apply only to contractor-level exams. An out-of-state journeyman or HVAC technician can work for a licensed South Carolina contractor without any state credential and, if a card is required locally, applies to CAGC.
Common questions
- Do I have to take the Connecticut journeyman HVAC technician exam if I'm licensed in South Carolina?
- Yes. Connecticut requires the trade exam on this path.
- What does it cost to get a Connecticut journeyman HVAC technician license from South Carolina?
- Published fees on this path total $269, not counting exam vendor fees or bonds.
- Do my South Carolina work hours count in Connecticut?
- Yes. Documented out-of-state experience counts toward Connecticut's eligibility requirements.
- Does it work the other way, from Connecticut to South Carolina?
- Not necessarily. Reciprocity is directed. Going from Connecticut to South Carolina, the mechanism is not applicable.
Sources
- Connecticut General Statutes Chapter 393 - Occupational Licensing (Electrical, Plumbing and Piping, Heating, Cooling...) · CGS §§ 20-330, 20-333, 20-333a, 20-334a, 20-335 · Connecticut General Assembly · Statute · verified September 23, 2026
- Connecticut DCP - Heating, Cooling and Sheet Metal Work Licenses (application paths, fees, renewal) · Connecticut Department of Consumer Protection · Agency Page · verified September 23, 2026
- Connecticut DCP - Heating Journeyperson: Equivalent Experience and Training · Connecticut Department of Consumer Protection · Agency Page · verified September 23, 2026
- Connecticut DCP - Heating Journeyperson: Equivalent Out of State License · Connecticut Department of Consumer Protection · Agency Page · verified September 15, 2026
- Connecticut DCP - Heating, Piping, Cooling and Sheet Metal Work Examining Board · Connecticut Department of Consumer Protection · Agency Page · verified September 15, 2026
- Connecticut DCP - Heating, Piping and Cooling License Types and Scope of Work · Connecticut Department of Consumer Protection · Agency Page · verified September 15, 2026
- Connecticut DCP Occupational Licensing - Heating, Piping and Cooling Trades Candidate Information Bulletin (PSI, updated 2/4/2026) · Connecticut Department of Consumer Protection / PSI Services LLC · Form · verified September 23, 2026
- EPA Section 608 Technician Certification Requirements · 40 CFR Part 82, Subpart F (Clean Air Act §608) · U.S. Environmental Protection Agency · Other · verified September 15, 2026
Verified dates are when a person last opened each source and confirmed the facts above. Cite the board, not us.