LicensebyState

Mississippi to New Mexico: master plumber license reciprocity

No credit· Start overVerified September 16, 2026· 5 sources

Mississippi does not issue a statewide master plumber license, so there is nothing to transfer. Here is New Mexico's standard path for out-of-state applicants.

Your origin state does not issue a statewide license at this level, so there is no license to transfer. The destination's standard out-of-state path is shown; expect to meet it in full.

Reference only, not legal advice. Rules change; confirm with the licensing board before you apply. Full disclaimer.

Out-of-state master plumber or plumbing contractor (all states)

Your out-of-state credentials give no advantage. You meet the destination's requirements from scratch.

An out-of-state master plumber or plumbing contractor receives no exam waiver in New Mexico. The individual files the notarized Qualifying Party application and work-experience affidavits with PSI ($36) showing four years of plumbing experience within the ten years before application (out-of-state experience is accepted on the same affidavits), is pre-approved, then must pass the 100-question open-book MM-1 Plumbing exam ($68.88, 75% to pass) and the Contractor's Business and Law exam ($68.88) or complete an approved business and law course in its place; passing scores are valid for one year. The business then applies to PSI for the MM-1 (or MM-98) contractor's license with a $36 application fee, the license fee ($50 per year or $100 for two years for MM-1; $100 per year or $200 for two years for MM-98), a $10,000 license bond, a New Mexico tax registration certificate and proof of workers' compensation coverage. Because New Mexico has no master plumber certificate, an out-of-state master who only wants to work with the tools applies for the JP journeyman certificate under the journeyman path instead.

Neither the RLD page, 14.6.3/14.6.4 NMAC nor the PSI contractor bulletin describes any substantial-equivalence review for contractors or qualifying parties from another state; the statutory reciprocity authority in NMSA 60-13-14(C) has not been exercised for mechanical or plumbing classifications as far as any official page shows. The only statutory experience waiver (60-13-14(B)(8)(b)) applies to a qualifying party previously certified in New Mexico in the same classification. Fee conflict: 14.5.5.8 NMAC sets the contractor license application fee at $30 while the RLD page lists $36 for both the QP application and the company license application; the RLD/PSI figure is used here. An MM-98 candidate takes the individual MM-1 through MM-4 exams; no combined MM-98 exam is listed.

At a glance

Trade exam
Required
Law / code exam
Required
Out-of-state hours
Count toward eligibility

What you must already have

  • Four years of practical or related trade experience in the MM-1 plumbing classification within the ten years immediately before application (NMSA 60-13-14(B)(8); 14.6.6.11(B)(1) NMAC), verified on notarized work-experience affidavits

What you'll do to get licensed in New Mexico

  1. 1Application fee. Pay the application fee ($36). Qualifying Party application and work-experience affidavit fee paid to PSI (notarized; submitted by hand or mail to the PSI Albuquerque office).
  2. 2Trade exam. Pass the destination's trade exam. MM-1 Plumbing exam by PSI: 100 questions, 250 minutes, open book (2021 Uniform Plumbing Code, 2015 NM Plumbing Code 14.8.2 NMAC, 2021 Uniform Mechanical Code), 75% (75 points) to pass.
  3. 3Exam fee. Pay the exam fee ($68.88). PSI fee for the MM-1 trade exam, first attempt or retake.
  4. 4Law / code exam. Pass a law, rules, or code exam. Contractor's Business and Law exam (required of all new candidates) or a commission-approved Business and Law course taken with an approved vendor in its place.
  5. 5Exam fee. Pay the exam fee ($68.88). PSI fee for the Business and Law exam.
  6. 6Other. Certificate of qualification issuance fee (14.5.5.14(A) NMAC) ($6).
  7. 7Contractor license. Hold or obtain a contractor license ($36). MM-1 or MM-98 contractor's license application fee paid to PSI by the business (RLD page; 14.5.5.8 NMAC still reads $30), with tax registration certificate and the qualifying party's certificate or scores.
  8. 8License fee. Pay the license or certificate fee ($100). MM-1 contractor's license fee, $50 per year or $100 for the two-year term; MM-98 is $100 per year or $200 for two years (14.5.5.8 NMAC).
  9. 9Surety bond. Post a surety bond ($10,000). $10,000 contractor's license bond from a corporate surety authorized in New Mexico (NMSA 60-13-49), filed with the company license application.
  10. 10Insurance. Carry the required insurance. Workers' compensation coverage is required of all licensees by the Workers' Compensation Administration.

Published fees on this path total $273.76, excluding exam-vendor fees, bonds, and insurance.

What you'll need to buy or arrange

Exam preparation

Most boards contract PSI, Prov, or ICC for exams. Check which code edition the exam is written to before buying a prep course.

  • Trade exam
  • Exam fee · $68.88
  • Law / code exam
  • Exam fee · $68.88

Surety bond

A license or contractor bond is bought from a surety, not the state. Price is a small percentage of the bond amount and depends on your credit.

  • Surety bond · $10,000

Liability insurance

Some states require proof of general liability or workers' compensation coverage at licensing time.

  • Insurance

How New Mexico licenses master plumbers

New Mexico master plumber · “MM-1 Plumbing contractor qualifying party (certificate of qualification); MM-98 Mechanical covers MM-1 through MM-4

Statewide license

Verified September 16, 2026· 5 sources

Issued by New Mexico Regulation and Licensing Department, Construction Industries Division (CID), Mechanical Bureau; applications and exams processed by PSI

New Mexico has no 'master plumber' title. The credential above journeyman is the MM-1 Plumbing contractor classification (install, alter, repair, service and maintain plumbing, fixtures and piping, hot-water heating up to 30 psi or 400,000 BTU/hour, fuel and solar piping, pools, septic and sewer lines, controls at 24 volts or less; natural gas piping requires MM-2), or the MM-98 Mechanical classification that bundles MM-1 through MM-4 and four mechanical specialties. CID issues the contractor's license to the business and a personal, non-transferable certificate of qualification to the qualifying party, the individual who documented four years of experience in the classification within the past ten years and passed the MM-1 trade exam and the Contractor's Business and Law exam, so this site maps the MM-1 qualifying party to the master level. Even with an MM-1 license, hands-on plumbing must be done by or under a certified JP journeyman. CID publishes reciprocity only for EE-98J electrical journeymen; no reciprocity, endorsement or exam waiver is published for plumbing qualifying parties or contractors, although NMSA 60-13-14(C) allows the division to enter into reciprocal agreements with states having equivalent requirements.

Moving to New MexicoLeaving New Mexico

Why Mississippi has nothing to transfer

Mississippi master plumber

Licensed by cities and counties

Verified September 16, 2026· 9 sources

Mississippi does not issue a personal master plumber license. The state-level plumbing credential is the Mississippi State Board of Contractors (MSBOC) contractor license: the commercial Mechanical major classification or its 'Plumbing (Test Required)' specialty (required on commercial jobs over $50,000; application and renewal $400, $300,000/$600,000 liability insurance, CPA-reviewed financial statement showing $50,000 net worth for Mechanical or $20,000 for the Plumbing specialty) or Residential Plumbing / Residential Mechanical (required for residential plumbing subcontracting over $10,000 in remodeling or $50,000 new construction; application $50, renewal $100). The license is issued to the business through a Certificate of Responsibility with a named qualifying party who passes the open-book PSI Plumbing (or Residential Plumbing) trade exam and the mandatory Mississippi Law and Business Management exam, so a master plumber who only wants to work for an employer has nothing to transfer to at the state level; the personal master credential exists only in cities such as Southaven (Master trade license, $100, which itself requires an active MSBOC license, a $10,000 bond and liability insurance) and Gulfport (contractor license issued to the qualifying party, $100). MSBOC waives its plumbing trade exam, for $50 per exam, for qualifying parties who hold a current license obtained by examination from the Alabama Plumbers and Gas Fitters Examining Board (commercial Plumbing exam only), the Ohio Construction Industry Licensing Board (Plumbing), the South Carolina Residential Builders Commission (Residential Plumbing, no discipline in three years) or the Tennessee Board for Licensing Contractors (all exams, no discipline in the last year); the Alabama General Contractors Board, Arkansas and Louisiana agreements expressly exclude plumbing, and the Business and Law exam is never waived.

How local licensing works in Mississippi

State contractor license (business). MSBOC issues commercial and residential contractor licenses to companies through a Certificate of Responsibility. The commercial Mechanical major classification 'involves all aspects of heating, cooling, refrigeration and associated equipment piping and ductwork as well as plumbing work' and carries 15 specialties including Plumbing, Process Piping, Underground Utilities, Fueling Systems and Irrigation Systems (all test required); an applicant may instead take only the Plumbing specialty. The qualifying party (owner, officer or responsible managing employee) passes the PSI open-book trade exam and the Mississippi Law and Business Management exam; fees are $400 application ($400 annual renewal, $100 per additional classification), general liability insurance of $300,000 per occurrence / $600,000 aggregate, and a CPA-reviewed financial statement showing net worth of $50,000 for a major classification or $20,000 for a specialty. Residential Plumbing (Residential Plumbing exam) and Residential Mechanical (Residential HVAC and Residential Plumbing exams) require the Law and Business exam, a $50 application fee ($100 per additional classification, $100 renewal) and proof of liability insurance with no minimum.

MSBOC exam waivers for out-of-state qualifying parties. Reciprocity 'applies to waiver of a trade exam requirement only' ($50 per exam waived, plus a $25 verification fee) after the origin board completes MSBOC's Reciprocity Verification Form; the applicant must have held the origin license for one year and passed that board's exam. Plumbing waivers are available for the Alabama Plumbers and Gas Fitters Examining Board (commercial Plumbing exam only; current license, Alabama exam taken), Ohio CILB (Plumbing; no discipline in the last year), the South Carolina Residential Builders Commission (Residential Plumbing; no discipline in three years) and Tennessee ('the only state that waives Mechanical and Plumbing'; no discipline in the last year). The Alabama General Contractors Board entry waives 'all exams but Mechanical & Plumbing', Arkansas excludes 'any type of Mechanical (i.e. Plumbing, Boilers, Process Piping, HVAC)', and Louisiana 'CAN WAIVE HVAC BUT NOT MECHANICAL OR PLUMBING'; Georgia, North Carolina, the South Carolina Contractors Licensing Board, Florida and California agreements do not reach plumbing. Separately, Form UROL under the Universal Recognition of Occupational Licenses Act (Miss. Code 73-50-2) waives the trade exam for an individual who has established Mississippi residency and held a similar license in any state for at least one year, and the Military Family Freedom Act (73-50-1) applies to military members and families. Every path still requires the Business and Law exam and full application review.

Southaven. Master trade license $100: application, photo ID of the license qualifier, certificate of liability insurance, a $10,000 general surety bond in favor of the city, an active MSBOC contractor's license certificate and the company EIN. An out-of-state applicant without an MSBOC license must provide a letter of good standing from a municipality where their license is active and may not take residential projects or commercial projects over $50,000; reciprocity questions are referred to MSBOC. Confirmed for mechanical and electrical on 2026-09-15; the plumbing card was not separately confirmed because the form could not be reopened on 2026-09-16.

Gulfport. Contractor license issued to the qualifying party ($100, waived with an MSBOC Certificate of Responsibility): notarized application, current MSBOC license if any, five reference letters (waived with an MSBOC license), $100,000/$300,000 liability insurance naming the city, home-jurisdiction privilege license and photo ID. No reciprocity provision.

Jackson, Hattiesburg, Biloxi, Tupelo. Master plumber programs in these cities could not be verified from an official page in this pass (Jackson redirected, Hattiesburg plumbing ordinance 404); contact each building department.

Moving to MississippiLeaving Mississippi

Common questions

Do I have to take the New Mexico master plumber exam if I'm licensed in Mississippi?
Yes. New Mexico requires the trade exam on this path, plus a law or code exam.
What does it cost to get a New Mexico master plumber license from Mississippi?
Published fees on this path total $273.76, not counting exam vendor fees or bonds.
Do my Mississippi work hours count in New Mexico?
Yes. Documented out-of-state experience counts toward New Mexico's eligibility requirements.
Does it work the other way, from New Mexico to Mississippi?
Not necessarily. Reciprocity is directed. Going from New Mexico to Mississippi, the mechanism is not applicable.

Sources

  1. Construction Industries Licensing Act, NMSA 1978 Chapter 60, Article 13 (RLD compilation as of July 1, 2021) · NMSA 1978 §§ 60-13-14, 60-13-38, 60-13-49 · New Mexico Regulation and Licensing Department · Statute · verified September 16, 2026
  2. 14.5.5 NMAC - Construction Industries General Provisions: Fees · 14.5.5.8, 14.5.5.9 and 14.5.5.14 NMAC · New Mexico Commission of Public Records, State Records Center and Archives · Admin Rule · verified September 16, 2026
  3. 14.6.6 NMAC - Construction Industries Licensing: Classifications and Scopes (mechanical and plumbing) · 14.6.6.11 NMAC · New Mexico Commission of Public Records, State Records Center and Archives · Admin Rule · verified September 16, 2026
  4. State of New Mexico Contractor (Qualifying Party) Examinations Candidate Information Bulletin (PSI) · PSI Services for the NM Construction Industries Division · Other · verified September 16, 2026
  5. NM Regulation and Licensing Department - Apply for a Construction Industries License · New Mexico Regulation and Licensing Department, Construction Industries Division · Agency Page · verified September 16, 2026

Verified dates are when a person last opened each source and confirmed the facts above. Cite the board, not us.

Report an error on this page

Related