Illinois to Connecticut: journeyman electrician license reciprocity
Illinois does not issue a statewide journeyman electrician license, so there is nothing to transfer. Here is Connecticut's standard path for out-of-state applicants.
Your origin state does not issue a statewide license at this level, so there is no license to transfer. The destination's standard out-of-state path is shown; expect to meet it in full.
Reference only, not legal advice. Rules change; confirm with the licensing board before you apply. Full disclaimer.
Journeyperson by equivalent out-of-state license (all states)
Your out-of-state credentials give no advantage. You meet the destination's requirements from scratch.
An electrician licensed in any other state applies under DCP's 'Electrical Journeyperson - Equivalent Out of State License' path. DCP reviews one out-of-state license for equivalency: it must have required the same number of classroom hours (720 for the E-2), an equivalent classroom curriculum, and the same on-the-job training hours (8,000 for the E-2) as the Connecticut license. The applicant submits a copy of the license, an official license verification, the laws and regulations that set the requirements met to obtain it, and the scope of work for that license; only one license will be reviewed and the $90 application fee is non-refundable. If the license is found equivalent, DCP approves the applicant to sit the E-2 exam with PSI ($59 per portion), and the license is issued after passing on payment of the $120 initial license fee. The out-of-state license does not waive the Connecticut exam because Connecticut has no reciprocal agreements. If the license cannot be shown equivalent, the applicant must instead document 720 classroom hours and 8,000 OJT hours under the equivalent experience and training path.
DCP's out-of-state license page does not itself restate that the exam is required; the exam requirement follows from the Electrical License page (exam vendor fees due on every path), CGS 20-333 (competency shown by examination) and the PSI bulletin (DCP determines eligibility, then the candidate tests). CGS 20-333a permits licensure without examination only where the other state reciprocates for Connecticut licensees, and DCP states no such agreements exist. Typical processing time is not published.
At a glance
- Trade exam
- Required
- Law / code exam
- Not required
- Out-of-state hours
- Count toward eligibility
What you must already have
- Your Illinois license must be active and in good standing.
- The out-of-state license must be equivalent: it required the same classroom hours (720), an equivalent curriculum, and the same OJT hours (8,000) as the Connecticut E-2Only one out-of-state license is reviewed for equivalency.
- You must document at least 8,000 hours of qualifying work experience.On-the-job training hours required for the E-2; demonstrated through the equivalent out-of-state license or, failing that, through notarized employer letters under the experience and training path.
What you'll do to get licensed in Connecticut
- 1Application fee. Pay the application fee ($90). Journeyperson application fee, non-refundable (CGS 20-333).
- 2Other. Copy of the out-of-state license, official license verification, the laws/regulations listing the requirements met to obtain it, and the scope of work for that license.
- 3Trade exam. Pass the destination's trade exam. E-2 Unlimited Electrical Journeyperson exam administered by PSI: 80 questions, 3.5 hours, 70% to pass, open book (2020 or 2023 NEC).
- 4Exam fee. Pay the exam fee ($59). PSI examination fee per portion (same fee for retakes).
- 5License fee. Pay the license or certificate fee ($120). Initial license fee for a journeyperson license after passing the exam (CGS 20-335); renews annually for $120.
Published fees on this path total $269, excluding exam-vendor fees, bonds, and insurance.
What you'll need to buy or arrange
Exam preparation
Most boards contract PSI, Prov, or ICC for exams. Check which code edition the exam is written to before buying a prep course.
- Trade exam
- Exam fee · $59
How Connecticut licenses journeyman electricians
Connecticut journeyman electrician · “E-2 Unlimited Electrical Journeyperson”
Statewide license
Connecticut licenses electricians statewide through the Department of Consumer Protection (DCP); the journeyman-level license is the E-2 Unlimited Electrical Journeyperson, which allows all electrical work defined in CGS 20-330 while employed by a licensed contractor (limited journeyperson classes such as C-6, L-2, L-6, T-2 and PV-2 also exist). A new E-2 applicant qualifies through a Connecticut apprenticeship, through equivalent experience and training, or by holding an equivalent out-of-state license, and in every path must pass the PSI-administered E-2 exam (80 questions, 3.5 hours, 70%, open book on the 2020 or 2023 NEC). DCP states that Connecticut does not have reciprocal agreements with any other jurisdiction, even though CGS 20-333a would allow the Commissioner to waive the exam for licensees of states that reciprocate. The application fee is $90, the exam is $59 per portion, and the initial license fee is $120; licenses expire every September 30 and renew for $120.
Why Illinois has nothing to transfer
Illinois journeyman electrician
Licensed by cities and counties
Illinois does not issue a statewide journeyman electrician license; the Illinois Department of Financial and Professional Regulation does not license electricians at any level, and state law only authorizes municipalities to register electrical contractors. Licensing of individual electricians is done, where it exists, by cities and counties under their own ordinances, and requirements vary by jurisdiction. In the largest jurisdictions the individual credential is a supervising or master-level license (Chicago's Supervising Electrician, Springfield's Electrical License based on the ICC Master Electrician exam) rather than a journeyman card, and non-supervising electricians work as employees under that licensed person or contractor. An out-of-state journeyman license has no state-level recognition in Illinois; a journeyman must check the rules of each municipality where they will work and apply locally if that municipality licenses individuals.
How local licensing works in Illinois
How local licensing works. Illinois has no state electrician license and no state electrical board. The Illinois Municipal Code (65 ILCS 5/11-33-1) allows each municipality to require registration of electrical contractors, with an annual fee of $25, and provides that a contractor registered in one municipality cannot be required to register or pay a fee in another. Anything beyond registration (examinations, experience requirements, supervising or master licenses) comes from each city's or county's own ordinance. Employees of an electrical contractor are expressly excluded from the statutory definition of 'electrical contractor', so state law does not require any personal license for a journeyman-level worker.
Chicago. The Department of Buildings licenses Supervising Electricians (individuals) and Electrical Contractors (businesses). There is no Chicago journeyman license. The supervising electrician exam requires age 21 and at least 2 years of experience under a supervising electrician or equivalent, verified by supervisor letters; general and low-voltage exams are offered through Continental Testing Services (2026 fees: $150 exam, $150 initial license, $150 annual renewal). For 'Class 1' work (buildings over 55 feet or large assembly occupancies before a certificate of occupancy), every worker must be a licensed supervising electrician or have completed or be enrolled in a U.S. Department of Labor-recognized apprenticeship of at least 8,000 hours; this apprenticeship standard is the closest thing Chicago has to a journeyman qualification. All other work is done by employees under the contractor's supervising electrician. Chicago's pages do not describe any reciprocity or endorsement for out-of-state licenses.
Springfield. The Building and Zoning Department issues an Electrical License to individuals who document 5 years of electrical experience (2 supervisory) and pass the ICC National Standard Master Electrician exam (W16); the Springfield Electrical Commission approves applications and the fee is $25. A limited grandfather clause applies to licenses from other Illinois or out-of-state municipalities with reciprocal testing that were issued before 10/10/2007; otherwise the ICC exam is required. Contractors performing work in the city must also register.
Peoria. Electrical licenses are issued to individuals, not businesses ($150 annual). Holders of Normal or Pekin licenses may register without testing; everyone else must submit an ICC contractor exam certificate (2017 code cycle or newer).
Rockford. Electrical contractors are not licensed, only registered ($25 per calendar year, or free with proof of current registration or license in another Illinois municipality).
Naperville and Aurora. Both accept current ICC certifications (Standard Master Electrician for commercial, Standard Residential Electrician for residential) or a license from a listed testing municipality in lieu of local testing; Naperville stopped issuing its own electrical licenses after 2022 and now registers electrical contractors. Insurance naming the city is required.
Elgin. Requires a contractor's license from any Illinois city that gives a written NEC-based examination, or Elgin's own exam administered through CLEC Enterprises.
Unincorporated Cook County. Electrical contractors must register ($150 initial, $75 annual renewal per trade), provide $1,000,000 general liability insurance, and submit a supervising electrician's license from an Illinois city, town or village that has an electrical commission administering an examination.
Out-of-state holders. None of these jurisdictions publish a reciprocity or endorsement path for licenses from other states. In practice the portable credentials inside Illinois are the ICC National Standard Master/Residential Electrician exams and licenses from testing municipalities such as Chicago; an electrician arriving from another state should expect to take the ICC exam or the local exam and apply separately in each municipality that licenses individuals.
Common questions
- Do I have to take the Connecticut journeyman electrician exam if I'm licensed in Illinois?
- Yes. Connecticut requires the trade exam on this path.
- What does it cost to get a Connecticut journeyman electrician license from Illinois?
- Published fees on this path total $269, not counting exam vendor fees or bonds.
- Do my Illinois work hours count in Connecticut?
- Yes. Documented out-of-state experience counts toward Connecticut's eligibility requirements.
- Does it work the other way, from Connecticut to Illinois?
- Not necessarily. Reciprocity is directed. Going from Connecticut to Illinois, the mechanism is not applicable.
Sources
- Connecticut General Statutes Chapter 393 - Occupational Licensing (Electrical, Plumbing and Piping, Heating, Cooling...) · CGS §§ 20-333, 20-333a, 20-334a, 20-335 · Connecticut General Assembly · Statute · verified September 15, 2026§20-333: non-refundable application fee of $90 for limited licenses and journeyman-type licenses under 20-334a(a)(2)-(3) and $150 for unlimited contractor licenses under 20-334a(a)(1); competency is shown by examination. §20-333a Reciprocity: the Commissioner may grant a license without examination to a currently practicing, competent person holding a similar license from another state with substantially similar or higher requirements, but only if that state grants the same privilege to Connecticut licensees; DCP reports no such agreements exist. §20-334a(a)(1)(A): an unlimited contractor's license may be issued to a person who served as a journeyman in the trade for at least two years 'and, if such service as a journeyman was outside this state, has furnished evidence satisfactory to the appropriate state board or the department that such service is comparable to similar service in this state', and has passed the examination; (a)(2)(A): an unlimited journeyman's license requires a bona fide apprenticeship including not less than four years' experience and passing the state licensure examination. §20-335: initial license fee $150 for a contractor's license and $120 for any other license; licenses expire annually; renewal $150 contractor / $120 other. The page returned a TLS certificate error to the fetch tool on 2026-09-15 and was downloaded directly with curl to read the section text.
- Connecticut DCP - Electrical License (application paths, fees, renewal) · Connecticut Department of Consumer Protection · Agency Page · verified September 15, 2026Lists the six application paths (contractor: 2+ years as journeyperson, equivalent experience and training, equivalent out-of-state license; journeyperson: Connecticut apprenticeship, equivalent experience and training, equivalent out-of-state license). Application fee: contractor $150, journeyperson $90, non-refundable. Renewal: contractor $150, journeyperson $120; all licenses expire September 30 annually. States 'Separate fees will be due to the exam vendor at time of exam registration' and, verbatim, 'Connecticut does not have reciprocal agreements with any other jurisdiction.'
- Connecticut DCP - Electrical Journeyperson: Equivalent Out of State License · Connecticut Department of Consumer Protection · Agency Page · verified September 15, 2026Defines an equivalent out-of-state license as one that required the same number of classroom hours, equivalent classroom curriculum, and on-the-job training hours as the Connecticut license applied for. Table: E-2 requires 8,000 OJT hours and 720 classroom hours (C-6 4,000/360, L-6 4,000/288, PV-2 4,000/324, T-2 4,000/288, L-2 8,000/576, C-8 2,000/144). Required documents: copy of the out-of-state license, license verification, the laws and regulations showing the requirements met to obtain it, and the scope of work for that license. Only one out-of-state license is reviewed; application fees are non-refundable; if equivalency cannot be proven the application is not approved on this basis.
- Connecticut DCP - Electrical License Types and Scope of Work · Connecticut Department of Consumer Protection · Agency Page · verified September 15, 2026E-1 Unlimited Electrical Contractor: all electrical work as defined in CGS 20-330. E-2 Unlimited Electrical Journeyperson: all electrical work, only while employed by a properly licensed contractor. Also lists the limited classes (C-5/C-6, C-7/C-8, L-1/L-2, L-5/L-6, T-1/T-2, PV-1/PV-2).
- Connecticut DCP Occupational Licensing - Electrical Trades Candidate Information Bulletin (PSI, updated 2/4/2026) · Connecticut Department of Consumer Protection / PSI Services LLC · Other · verified September 15, 2026Eligibility for examination is determined by the State (DCP approves the application, then PSI schedules). Fee: $59 per examination portion, first attempt or retake, non-refundable. Journeypersons pass only a trade portion; contractors must pass both a trade portion and the Business and Law portion (50 questions, 2 hours, 70%, based on the NASCLA Contractors Guide, Connecticut 6th edition). E-1 Unlimited Electrical Contractor trade exam: 100 questions, 4 hours, 70%, open book. E-2 Unlimited Electrical Journeyperson: 80 questions, 3.5 hours, 70%, open book. Code questions are based on the 2020 or 2023 National Electrical Code. Eligibilities are valid for one year; a passed portion is valid for two years.
Verified dates are when a person last opened each source and confirmed the facts above. Cite the board, not us.